Reconstituting HCG for Dummies

[Kubes]

Reconstituting HCG for Dummies

03-04-2024, 11:37 AM
How to reconstitute HCG.......by Trashman

HCG usually comes as 5,000iu.
If you were to use 1ml to dilute this, you'd have 5,000iu/ml
If you were to use 2ml to dilute this, you'd have 2,500iu/ml
If you were to use 5ml to dilute this, you'd have 1,000iu/ml

HCG also comes as 2,500iu
If you were to use 1ml to dilute this, you'd have 2,500iu/ml
If you were to use 2 ml to dilute this, you'd have 1,250iu/ml


HCG also comes as 10,000iu
If you were to use 1ml to dilute, you'd have 10,000iu/ml
If you were to use 5ml to dilute, you'd have 2,000iu/ml

There are also 11,000iu batches
If you were to use 1ml to dilute, you''d have 11,000iu/ml
If you were to use 5ml to dilute, you'd have 2,200iu/ml

To find the iu/ml for a different number, take the total iu of HCG and divide by the number of ml you plan to dilute it with (for example, 5,000iu/2ml=2,500iu/ml)

The more you dilute it, the more accurate your dosage will be. For example, using 2,500iu/ml, if you were to inject 500iu there could be measuring error. Let's say the margin of error is +/- .05cc. You could be injecting between 375iu and 625iu. Now, taking the 1,000iu/ml dosage, the +/-.05cc margin of error is lower (also using a dose of 500iu). The dose would be somewhere between 450iu and 550iu.

At 1,000iu/ml, .5cc is 500iu, .2cc is 200iu, and .25cc is 250iu.
At 2,200iu/ml, .5cc is 1,100iu, .2cc is 440iu, and .25 is 550iu.

To find the number of iu in any increment, take the iu/ml number and multiply it by the cc you want (for example, 1,000iu/ml*.5cc=500iu).
If you want to take a certain iu, divide the number of iu by the iu/ml to find out how many cc you need (for example, if you want 500iu and you have a dose at 2,000iu/ml, 500iu/2,000iu/ml=.25ml)

Using HCG
HCG should be stored in a refrigerator immediately after reconstitution. It can last about 4 weeks or so. Swirl it gently before injecting but handle it carefully. Letting HCG go to room temperature after it has been chilled can damage it. If this happens, it is safer to throw it away and start over. When reconstituting, the reconstitution liquid should not be directly shot at the HCG biscuit but rather run down the side of the vial. The HCG amp gets broken and diluted with a little water. Then you draw it out into a slin pin and shot the water down the side of the vial. Add more water if desired. It is best to used a new, sealed, sterile vial for reconstitution. HCG can be shot either in a muscle (IM) or subcutaneously (sub-q). It is more common to shoot HCG sub-q to avoid scar tissue in the muscle. HCG is typically shot with an insulin pin to minimize pain. A typical 25-30g pin with a .5cc barrel (or as small as you can get) is recommend (a smaller barrel minimizes the margin of error). A sub-q injection is typically done in the abdominal region by pinching a layer of fat and injection the HCG between the fat and muscle.


MIXING HCG
Break open both amps. Then with a 25g pin, draw up the 1ml of 'solvent' (which is bacteriostatic water) and inject into the amp with powder. It will mix to a clear solution. Draw this solution up with the same 25g pin and inject into a sterile vial. Be sure to wipe the top of the sterile vial with an alcohol pad first.

Now draw 4 ml of bacteriostatic water (again wiping the top of the bacteriostatic water vial with a alcohol pad before drawing) and inject into the sterile vial. You will now have a 1ml = 1000iu solution. Use slin pins and inject sub-q. With this concentration, 25 on the slin pin equals 250iu's, 50 equals 500iu's etc.
Refrigerate the vial and use as needed. It will last reconsituted for 60 days.
Note: Injected subcutaneous at the navel